Uit Hack42
(Add some notes on what I did to get it to work properly on ubuntu 18.04) |
|||
| Regel 19: | Regel 19: | ||
Zoektermen: vinylcutter, snijplotter, hobbyplotter, snijplotter | Zoektermen: vinylcutter, snijplotter, hobbyplotter, snijplotter | ||
| + | |||
| + | == gmc's experience with ubuntu 18.04 == | ||
| + | |||
| + | * Connect the plotter with usb to your laptop | ||
| + | * Install the printer in your system (cups) by browsing to localhost:631 (not sure if this is needed, I don't think so) | ||
| + | * Choose 'Raw' as the 'Make', 'Raw Queue' as model | ||
| + | * Start inkcut | ||
| + | ** Device->Setup | ||
| + | *** General: driver = Silhouette Portrait | ||
| + | *** General: Check customize, set width to 24cm, length 300cm | ||
| + | *** Device: Output: check 'Swap X/Y' | ||
| + | *** Connection: Type = parallel port, Port will be something like /dev/usb/lp2 | ||
| + | ** On the left, activate 'Material' | ||
| + | ** Set the plot area (first number on top is width, i set it to 240mm for the metamark e series sheets, height i didn't measure (my design wasn't that tall) | ||
| + | ** Now you can load a design, maybe set 'Graphic Copies' to fill the sheet | ||
| + | ** Then Device->Send to Device et voila | ||
Versie van 23 aug 2019 20:35
| Hack42 Tool Vinylsnijder | |
|---|---|
  | |
| Naam | Vinylsnijder |
| Omschrijving | Silhouette Portrait |
| Te gebruiken door | Deelnemer |
| Kost gebruik geld? | |
| Locatie | Makerlab |
| Eigenaar | Hack42 |
| THT | |
{{{Name}}}
{{#ifexist: | |
Tool_Vinylsnijder_Picture.jpg
Eet vinyl (20cm breed)
Vinyl is aanwezig in meerdere kleuren
Er is Windows and Mac-software meegeleverd. Onder Linux wordt de cutter herkend als Parallel-over-USB device.
Werkt naar behoren met https://www.codelv.com/projects/inkcut/ onder Linux en OSX (Windows niet getest). Vraag Gebruiker:raboof eventueel voor hulp.
We zijn ook een grotere oudere vinylsnijder aan het opknappen, de AristoVinylsnijder
Zoektermen: vinylcutter, snijplotter, hobbyplotter, snijplotter
gmc's experience with ubuntu 18.04
- Connect the plotter with usb to your laptop
- Install the printer in your system (cups) by browsing to localhost:631 (not sure if this is needed, I don't think so)
- Choose 'Raw' as the 'Make', 'Raw Queue' as model
- Start inkcut
- Device->Setup
- General: driver = Silhouette Portrait
- General: Check customize, set width to 24cm, length 300cm
- Device: Output: check 'Swap X/Y'
- Connection: Type = parallel port, Port will be something like /dev/usb/lp2
- On the left, activate 'Material'
- Set the plot area (first number on top is width, i set it to 240mm for the metamark e series sheets, height i didn't measure (my design wasn't that tall)
- Now you can load a design, maybe set 'Graphic Copies' to fill the sheet
- Then Device->Send to Device et voila
- Device->Setup