Uit Hack42
| Project: OneWireSwitch | |
|---|---|
  OneWireSwitch | |
| Naam | OneWireSwitch |
| Door | BugBlue |
| Status | Afgerond |
| Madskillz | solderen, slijpen, zagen, schroeven, programmeren |
| Doel / Omschrijving | |
| Onewire switch bouwen op basis van een oude switch | |
| Alle Projecten - Project Toevoegen | |
noezThe idea
- Take a (broken) 19" switch
- Saw off the exces part of the switch you don't need (everything except the ports and the PCB directly underneath)
- figure out the pins
- Pin 1: ground
- pin 2: data
- pin 3: VCC
- get a rasterized printboard and some headers
- make a shield for your arduino
- Connect all the data pins to the data cables for the ports (16 in this case)
- solder 16 resistors (1k or 4k7) from 5V VCC to all the datapins
- solder 5V and GND
- screw the arduino to the board
- connect the shield to the arduino
- insert a USB cable
- upload the software
- close the case
- apply stickers
- place the switch in the rack
- If any time is left you can connect some leds
The software
please type in here...
Gezocht
Nyancat stickers. Ter hoogte van 1U :)